|
|
|
|
|
|
|
|||
|
|
|
||
|
|
|
|
|
|
|
|||
 |
 |
 |
 |
 |
 |
 |
|||||||||||||||||||||
|
Form Hardware  The Durand Attached Pin: The key to the Durand Attached Pin is a protected, stainless steel ball bearing which rides against the specially hardened pinshaft. A stainless steel spring (in compression) holds the ball bearing firmly in place. An Allen-head screw keeps the spring in compression and provides easy access to all parts.Part No. AP | |||||||||||||||||||||||||||
|
Standard Pin 5/8” diameter. Heat treated for durability. Part No. PIN 
|
Filler Pin For use with 2” or less filler panel. Runs through panel to other side rail and wedge. Part No. 1-2FP 
| ||||||||||||||||||||||||||
|
Flat-Head Pin Used when pouring a wall away from an existing wall. Allows placement of a tie against the wall. Part No. FHP 
|
Aluminum Base Tie Pin (Silver Bullet) Disposable, use it and leave it. (Caution: Not for use in place of standard pin.) Part No. ABTP 
| ||||||||||||||||||||||||||
|
Curved Wedge Curved for easy removal. Part No. CU WED 
|
Standard Wedge Part No. ST WED 
| ||||||||||||||||||||||||||
|
90º Corner Clip Secures two outside forms together with pins and wedges to form a 90º corner. One clip on each tie hole. Part No. CC90 
|
90º Corner Clip with Pin Part No. CC90 W/P 
| ||||||||||||||||||||||||||
|
45º Corner Clip Secures two outside forms together with pins and wedges to form a 45º corner. One clip on each tie hole. Part No. CC45 
|
Cap Clip Used to attach cap forms to the top of forms without pins and wedges. Part No. CC 
| ||||||||||||||||||||||||||
|
Brick Ledge Nailer Pins to top of form and provides nailer for brick ledge. Part No. BLN 
|
Waler Bracket A full range of sizes. Specify: Smooth/Vertical Brick or Textured Brick.
| ||||||||||||||||||||||||||
|
Wedgeless Waler No wedge needed. Provides quick installation and stripping.
|
Wedged Stiff Back Bracket Used to keep high forming rigid vertically. A waler wedge is driven against lumber between the bracket flange. Example: If 2x4 walers were used with 2x4 stiff backs, you would use a 2x8 stiff back bracket.
| ||||||||||||||||||||||||||
|
2x4 – 2x12 Combination Waler Bracket Accepts a 2x4 waler and up to a 2x12 plank. Provides a wider platform. Part No. CWSB 
|
Combination Brick- Smooth Waler Combination smooth and brick walers. Part Nos. CBS 2x3 CBS 2x4 CBS 2x6 CBS 2x8 CBS 2x10 
| ||||||||||||||||||||||||||
|
Stiff Back Bracket Tightens the lumber against the forms. Keeps forms rigid vertically. Note: Brace forms plumb using side wall brace. Part Nos. 2x4 SB 2x6 SB 2x8 SB 2x10 SB 
|
Scaffold Bracket Stake pocket hole and holes to hold down planks. Part Nos. 24” 24 SB 36” 36 SB 
| ||||||||||||||||||||||||||